Is it good to coat in Fort Collins, CO this week?
A live 7-day go/no-go calendar for epoxy & resin floors in Fort Collins, built from the local forecast against the 5°F-above-dew-point rule. We lead with the signal a weather app misses: overnight condensation risk.
- Dew margin
- -1.2°F
- Overnight dew
- High
- Rain
- 5%
- Window
- —
High condensation risk overnight — surface dips to within -1.2°F of the 45°F dew point (low 44°F, 74% cloud, 2 mph wind). A fresh coat can blush/blister. Stop 4h before dew falls.
- Dew margin
- 19.7°F
- Overnight dew
- Low
- Rain
- 0%
- Window
- 10am–5pm
Cold mornings (down to 49°F, floor is 50°F) — wait for the surface to warm past midday before you coat.
- Dew margin
- 5.1°F
- Overnight dew
- Low
- Rain
- 0%
- Window
- 8am–5pm
Clear to coat: temps 66–85°F, RH under 26%, surface stays 5.1°F+ above the dew point, no rain in the cure window.
- Dew margin
- 5.7°F
- Overnight dew
- Low
- Rain
- 1%
- Window
- 8am–5pm
Clear to coat: temps 56–80°F, RH under 50%, surface stays 5.7°F+ above the dew point, no rain in the cure window.
- Dew margin
- 19.7°F
- Overnight dew
- Low
- Rain
- 3%
- Window
- 8am–5pm
Hot afternoon (88°F, ceiling 86°F) — coat early and follow the shade.
- Dew margin
- 18.9°F
- Overnight dew
- Low
- Rain
- 7%
- Window
- 8am–5pm
Clear to coat: temps 70–82°F, RH under 27%, surface stays 18.9°F+ above the dew point, no rain in the cure window.
- Dew margin
- 23.4°F
- Overnight dew
- Low
- Rain
- 1%
- Window
- 8am–5pm
Clear to coat: temps 66–84°F, RH under 26%, surface stays 23.4°F+ above the dew point, no rain in the cure window.
- High condensation risk overnight — surface dips to within -1.2°F of the 45°F dew point (low 44°F, 74% cloud, 2 mph wind). A fresh coat can blush/blister. Stop 4h before dew falls.
Hold off. These are forecast numbers — confirm the surface temperature on-site before you start.
Why these thresholds
Installing within 5°F of the dew point causes amine blush / carbamation — a cloudy, greasy, hazed floor. The slab surface temp, not the air, is what counts.
- • Surface temp must stay 5°F above the dew point through application and cure (ASTM D3276 / ISO 8502-42).
- • Air + surface in the 50–86°F band (low-temp lines to 50°F).
- • Humidity under 85%; ideally under 80%.
- • No rain for 24h after application.
- • We use the forecast ground-surface temperature as a surface-temp proxy — confirm on-site with an IR thermometer.
Free in the beta
Watch this job site 24/7
Get an email the moment overnight dew, rain, or an out-of-range stretch threatens a fresh coat — and a morning digest with the best window ahead. No app to check; we watch the forecast for you.