Is it good to coat in Salt Lake City, UT this week?
A live 7-day go/no-go calendar for epoxy & resin floors in Salt Lake City, built from the local forecast against the 5°F-above-dew-point rule. We lead with the signal a weather app misses: overnight condensation risk.
- Dew margin
- 10.5°F
- Overnight dew
- Low
- Rain
- 4%
- Window
- 11am–5pm
Cold mornings (down to 43°F, floor is 50°F) — wait for the surface to warm past midday before you coat.
- Dew margin
- 0°F
- Overnight dew
- High
- Rain
- 100%
- Window
- —
High condensation risk overnight — surface dips to within 0°F of the 35°F dew point (low 32°F, 100% cloud, 13 mph wind). A fresh coat can blush/blister. Stop 4h before dew falls.
- Dew margin
- 8.6°F
- Overnight dew
- Low
- Rain
- 45%
- Window
- —
Too cold to coat — daytime high only 45°F, below the 50°F minimum (even a low-temp line needs 50°F+).
- Dew margin
- -3.2°F
- Overnight dew
- High
- Rain
- 93%
- Window
- —
High condensation risk overnight — surface dips to within -3.2°F of the 36°F dew point (low 33°F, 100% cloud, 9 mph wind). A fresh coat can blush/blister. Stop 4h before dew falls.
- Dew margin
- 0.4°F
- Overnight dew
- High
- Rain
- 95%
- Window
- —
High condensation risk overnight — surface dips to within 0.4°F of the 27°F dew point (low 27°F, 8% cloud, 3 mph wind). A fresh coat can blush/blister. Stop 4h before dew falls.
- Dew margin
- 15.6°F
- Overnight dew
- Low
- Rain
- 17%
- Window
- —
Too cold to coat — daytime high only 45°F, below the 50°F minimum (even a low-temp line needs 50°F+).
- Dew margin
- 12.7°F
- Overnight dew
- Low
- Rain
- 14%
- Window
- —
Too cold to coat — daytime high only 47°F, below the 50°F minimum (even a low-temp line needs 50°F+).
- Cold mornings (down to 43°F, floor is 50°F) — wait for the surface to warm past midday before you coat.
Caution. These are forecast numbers — confirm the surface temperature on-site before you start.
Why these thresholds
Installing within 5°F of the dew point causes amine blush / carbamation — a cloudy, greasy, hazed floor. The slab surface temp, not the air, is what counts.
- • Surface temp must stay 5°F above the dew point through application and cure (ASTM D3276 / ISO 8502-42).
- • Air + surface in the 50–86°F band (low-temp lines to 50°F).
- • Humidity under 85%; ideally under 80%.
- • No rain for 24h after application.
- • We use the forecast ground-surface temperature as a surface-temp proxy — confirm on-site with an IR thermometer.
Free in the beta
Watch this job site 24/7
Get an email the moment overnight dew, rain, or an out-of-range stretch threatens a fresh coat — and a morning digest with the best window ahead. No app to check; we watch the forecast for you.